Ferris Sweep 3D Printed Base

I show above my very basic Ferris Sweep base for a mod created by Ben Vallack.

It positions the PCB at 7 degrees angle slightly over a desk surface.
It requires 6 mm silicone/rubber pads to keep the keyboard stable.
I use a thick pad to support my wrists when using the keyboard.

In the attached archive I included STL files for both hands. I printed mine in PLA with 0.2 mm layer height.

One reply on “Ferris Sweep 3D Printed Base”

I have updated the base to the most recent revision.
The archive contains also a tool that helps to cut pads to the required height.

Leave a Reply

Your email address will not be published. Required fields are marked *